
An electro-hydraulic thruster is a braking actuator that converts electrical energy into mechanical thrust. It is usually mounted on a drum brake or disc brake to overcome the brake spring force and release the brake.
It is important to understand that the thruster is not the brake itself. It is the driving component that releases or holds the brake open. When power is cut off, the brake spring applies the brake immediately. When energized, the piston rod extends to release the brake. For this reason, electro-hydraulic thrusters are commonly used in systems with "brake on power failure, release on power supply."
2. Basic Structure
An ED series thruster mainly consists of the following components:
electric motor;
impeller;
cylinder and piston;
piston rod;
hydraulic oil chamber;
housing and sealing components;
terminal box.
The motor drives the impeller at high speed. The impeller forces hydraulic oil into the cylinder, and oil pressure pushes the piston and piston rod upward. When power is cut off, the impeller stops and the return spring retracts the piston rod quickly.
3. Working Principle
3.1 Brake Release on Power Supply
The thruster is connected to the power supply.
The motor drives the impeller at high speed.
Hydraulic oil enters the cylinder under centrifugal force.
The piston and piston rod move upward.
The piston rod actuates the brake linkage.
The brake shoes move away from the brake wheel and the brake is released.

3.2 Brake Application on Power Failure
The power supply is disconnected.
The motor and impeller stop rotating.
Hydraulic oil returns to the oil chamber.
The return spring pushes the piston rod downward.
The brake spring presses the brake shoes against the brake wheel.
The equipment slows down or stops.

4. Why Choose ED Series Thrusters?
4.1 Stable Operation
The motor and impeller drive the hydraulic oil continuously, maintaining stable thrust and providing smoother brake release.
4.2 Wide Thrust Range
Common models provide rated thrust from 220 N to 3000 N. This makes them suitable for drum brakes and disc brakes of different sizes.
4.3 Fail-Safe Operation
When the thruster is de-energized, the brake spring acts immediately to apply the brake. This feature meets the common safety requirements of cranes, conveyors and metallurgical equipment.
4.4 Simple Structure and Easy Maintenance
ED series thrusters integrate the driving, hydraulic and actuating functions into one unit. They have fewer external interfaces, so installation and routine inspection are relatively easy.
5. How to Determine the Model
The numbers in the model generally indicate thrust and stroke levels. For example, ED50/6 should not be interpreted as a simple "50 times" or "6 times" relationship. It should be understood according to the rated thrust and rated stroke specified by the manufacturer.
When selecting a model, the following items should be confirmed in order.
5.1 Force Required to Release the Brake
The rated thrust of the thruster should not be less than the maximum force required to release the brake. Insufficient thrust may prevent the brake from fully releasing or may cause slow operation.
5.2 Required Stroke
The thruster stroke must satisfy the brake shoe clearance, linkage ratio and mounting requirements. Insufficient stroke may prevent the brake from releasing completely.
5.3 Mounting Dimensions
Confirm the mounting hole distance, mounting height, piston rod direction, base angle and brake interface. Otherwise, the thruster may not fit the application on site.
5.4 Power Supply
Check the voltage, number of phases, frequency and wiring method. Common models use 3-phase 380 V, 50 Hz, but requirements may vary in different markets, countries and equipment.






