1. Adjustment of the working stroke of the pusher: First, the spring force should be released to the minimum value, and then the lever is rotated to make the brake in the brake state and continue to rotate. At this time, the pusher pusher slowly rises, when the height of the lift reaches the pusher The adjustment is completed at 1/3 of the rated stroke.
2. The adjustment of tiles
When the brake is in the state of holding the brake, rotate the bolt in the follower so that the distance between the top of the brake and the brake pad is between 0.5-1mm.
3Moment torque adjustment: Rotate the spring puller to compress the spring and align the upper edge of the spring lower seat with the required torque.
4Adjustment of the equalization device for retraction distance: when adjusting the working stroke of the pusher, loosen the bolt, when the brake is in the state of the brake, then tighten the nut on the back of the bolt
5. Compensation mechanism adjustment: first make the pusher move several times, and then push the pusher up. Adjust the adjustment plate so that the lower edge of the adjustment plate just presses the dial, and then tighten the fixing bolt
6. Liner wear limit limit switch
Adjust the distance between the switch and the strike plate to L.
