A lot of people for the brake is not very understanding, however, brake can be divided into hydraulic brake and block brake two, different types of brake role is not the same, with different characteristics, we need to according to the specific equipment, the use of specific maintenance methods.
Gold band brake for example to share with you, in the use of this equipment, the need to pay attention to a few details.
1、 The lubricant is often added to the brake of the crane.
2、 Check the length of armature stroke regularly. Because in the operation process of the brake, the travel length of the armature will increase because of the wear of the cutting surface. When the length of the armature stroke cannot reach the normal value, it is necessary to adjust it to reproduce the small gap between the moving surface and the turntable. If the length of the armature stroke increases above the normal value, the suction may be greatly reduced. If the worn brake surface is replaced, the small gap between the brake surface and the rotary table shall be adjusted properly from the beginning.
3、 Always check the tightening degree of the bolts, especially the bolts of the electromagnet, the bolts of the electromagnet and the shell, the bolts of the yoke, the bolts of the electromagnet coil and the connection bolts.
4、 Regularly check the mechanical wear condition of movable parts, and remove the dust, hair and dirt on the surface of electromagnet parts.
I hope these information about crane brakes can help you, you can rely on these information more correct, reasonable application of hydraulic brakes.
Of course, there is a lot of information about brakes, hydraulic brakes, block brakes, if you are interested in this information, want to have a more comprehensive understanding, or want to buy brakes, welcome to contact the gold band brakes.
