Many brakes are in the form of electromechanical, because the inspection of the electrical part of the equipment is also not to be ignored.
Regarding the safe use of electrical parts, mainly the following aspects.
1, under the operating voltage, according to the traction machine operating mechanism, load duration and cycle operation, the measurement brake to reach a thermal stability state, measure the temperature rise of the brake coil.
When checking the voltage again, it should be in accordance with the working requirements, to ensure that within a reasonable range.
2, brake coil pressure test should meet the conductive part applied to the ground 1000 volts voltage, lasts 1 minute, without any fault.
3, after the completion of the brake device heating test, should also be the brake electromagnetic small suction voltage and high release voltage to be tested. 4, the new brake is installed with a brake monitoring switch.
Non-working is automatically stopped when the detected condition occurs, which also provides a safety guarantee for the use of the brake. 5, as an electrical part, the main function of the brake coil is the control circuit.
Therefore, in the process of use, should ensure the normal circuit, which is also to ensure that the brake normal operation of the premise. The method of using the electrical part of the brake is briefly introduced here. For more information, please follow our company's official website, where you have more information about brakes.
